Tif 5650A Halogen Leak Detector User Manual download pdf (Page 10)

MAINTENANCE

Negative Lead

Hilo negativo

Borne neegative

negative Meßleitung

Positive Lead

Hilo positivo

Borne positive

positive Meßleitung

Proper maintenance of your Leak Detector is very important. Carefully following

the instructions, outlined below, will reduce performance problems and increase

the life expectancy of the unit.

WARNING: TURN OFF UNIT BEFORE REPLACING THE SENSING TIP.

FAILURE TO DO SO MAY RESULT IN A MILD ELECTRICAL SHOCK!

• Keep the sensing tip clean: Prevent dust, moisture and grease build-up by

utilizing the provided tip protector. Never use the unit without the protector in

place.

Before using the unit always inspect the tip and protector to see that they are free

of dirt and/or grease. To clean:

1. Remove protector by grasping and pulling off tip.

2. Clean protector with shop towel and/or compressed air.

3. If the Tip itself is dirty it can be cleaned by unscrewing it and immersing in a

mild solvent, such as alcohol, for a few seconds, and then using compressed

air and/or a shop towel to clean.

NOTE: Never use solvents such as gasoline, turpentine, mineral spirits etc... as

these will leave a detectable residue and desensitize your unit.

• Sensing tip replacement: The tip will eventually wear out and

require replacement. It is difficult to predict exactly when this will

occur since tip longevity is directly related to the conditions and

frequency of use. The tip should be replaced whenever the beep

rate increases in frequency or becomes erratic, even in a clean

pure, air environment.

To replace the tip (Refer to the inset Figures on page 3.)

1. Make sure the unit is in the OFF position.

2. Remove the old tip by unscrewing in a counter-clockwise direction

3. Use the supplied replacement tip, located in the battery compartment, and

screw it on in a clockwise direction until finger tight.

• Batteries affect unit performance. When the selector switch is inthe ON posi-

tion the red power indicator light should be on. If the light does not come on,

then 2 new and/or tested size "C" Alkaline batteries should be installed. Batteries

must supply at least 2.2v (under load) to light power indicator and operate unit.

Always checkbattery voltage under load: Remove battery cover and turn unit on

Measure voltage across the batteries as indicated by arrows in the

following diagram.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 34 35

Comments to this Manuals

No comments

Tif 5650A Halogen Leak Detector User Manual Page 10

Comments to this Manuals

Related products and manuals for Equipment Tif 5650A Halogen Leak Detector